Front LCD Temp. Disp., you can either tape it next to the CPU cooler, on HDD or VGA, or just let it hang in the case depending on which temp. you want to monitor. Hook up the 4pin Input connector(Male) connected the Black-and-Red twisted cable to the 4pin Output connector(Female) from Power Supply to power on.

Mult-function Intelligent Thermometer

Specification

l        LCD Display Operation Manual: 

l         Cable HarnesS: 

l        Temperature Sensor Installation

CPU:   Sensor must be taped to the position near to CPU by temperature-resistance tape

VGA:  Sensor must be taped to the position near to IC by temperature-resistance tape

HDD:  Sensor must be taped to the position near to HDD by temperature-resistance tape

l         KEY-PRESS EXPLAIN:

  MODE KEY:

Select temperature. Display for HDD、VGA、CPU.

  UP KEY:

Switch ℃/℉ under stand-by status;  Time running under time setting status.

  SET KEY:

Time setting.

RESET:  

To reset.

l        OPERATE SPECIFICATION:

Hard Disk：

Moving sign “” is activated when HDD is in operation status.

Temperature Display：

“HI” displays When temperature value is over 99℃. “LO” displays When  below 0℃。The change of temperature will indicate will a scale.

  The tolerance is ±1℃when the temperature is between5℃-88℃; The tolerance is ±2℃ when the temperature is under 5℃ or over 88℃.

FAN ：

Must use the three pieces fan by INTEL admitted。

Moving sign “” is activated when the CPU fan operates。The fan speed is not indicated. “BE—BE--”shall alarm when CPU fan stops. Turn off the power, when alarm is activated. Check where is the problem and remove it.

Time display：

24 hours display。

Power：

 “” appears when there is power supplied to the computer。

“ 2032” Li Battery is adapted，when power id off, the time runs continuously。Normal life is more two years。

l        malfunction disposing

Press “RESET” key when temperature module can’t work as the malfunction happen.