|
Multifunctional Intelligent-Thermometer-Display
Installation
First, locate the thermal
sensors as shown in picture below, and secure each of them with tape to:
1) CPU. 2) HDD. 3) VGA. as shown
below.
Then, hook up the 4-pin input
connector ( male ) with Red/Black/Yellow wires to
4-pin output connector (
female ) with the same color wires from Power Supply.
For details please refer to the
following:
l
LCD
Display Operation Manual:
l
Cable
HarnesS:
l
Temperature Sensor Installation
  
CPU:
Sensor must be taped to the position near to CPU by temperature-resistance tape
VGA:
Sensor must be taped to the position near to IC by temperature-resistance tape
HDD:
Sensor must be taped to the position near to HDD by temperature-resistance tape
l
KEY-PRESS EXPLAIN:
MODE KEY:
Select
temperature. Display for HDD、VGA、CPU.
UP KEY:
Switch
℃/℉
under stand-by status; Time running under time setting status.
SET KEY:
Time
setting.
RESET:
To reset.
l
OPERATE SPECIFICATION:
Hard
Disk：
Moving sign
is activated when HDD is in operation status.
Temperature
Display：
HI
displays When temperature value is over 99℃.
LO
displays
When below 0℃。The
change of temperature will indicate will
a scale.
The tolerance is
±1℃when
the temperature is between5℃-88℃;
The tolerance is ±2℃
when the temperature is under 5℃
or over 88℃.
FAN
：
Must use the three pieces fan by INTEL admitted。
Moving sign
is activated when the CPU fan operates。The fan speed
is not indicated. BEBE--shall
alarm when CPU fan stops. Turn off the
power, when alarm is activated. Check where is the problem and remove it.
Time
display：
24 hours display。
Power：
appears when there is power supplied to the computer。
2032 Li Battery is adapted，when
power id off, the time runs continuously。Normal life
is more two years。
l
malfunction disposing
Press RESET key when temperature module cant
work as the malfunction happen.
|
Help
Best
Sellers
Chassis
Structure
